Lap Belt Installation - Britax ADVOCATE CLICKTIGHT User Manual

Britax Child Safety, Inc.

Lap Belt Installation

1. Remove the tether
from the tether storage
compartment and retainer
tabs and place it up and
over the child seat back.
2. Recline the unoccupied
child seat and place
forward-facing on the
vehicle seat. Ensure that
the base of the child seat
is flat on the vehicle seat
and no more than 3 in.
(7.6 cm) of the base hangs
over the edge of the
vehicle seat (see pages
26-27).
3. Open the CLICKTIGHT.
a. Press the dimple on
the CLICKTIGHT
dial.
b. Rotate dial clockwise
until CLICKTIGHT
releases and lift to
open.
4. Slide the vehicle belt into
the forward-facing belt
slots.
5. Ensure the vehicle belt is
not twisted and buckle
the seat belt.
6. Push down into the middle
of the child seating area
with moderate force
(approximately
45 lbs/20.4 kg),
compressing the vehicle
seat while tightening the
vehicle belt.
NOTE: Ensure that the
vehicle belt is locked as
directed by your vehicle
owner's manual.
18
3"
3a
3b
ADVOCATE/BOULEVARD CLICKTIGHT User Guide
7. Close the CLICKTIGHT.
– A click confirms the
CLICKTIGHT is secure.
NOTE: If the CLICKTIGHT
is difficult to close, repeat
step 6 with less tension in
the vehicle belt.
8. Attach the tether to a
designated anchor (see
vehicle owner's manual)
and remove slack (see
page 31).
Forward-Facing Installation with Lap Belt
9 Ensure that the logo on the CLICKTIGHT dial has
returned to a horizontal position.
9 Check that all connections are secure and straps are
not twisted.
9 Ensure that the recline indicator ball is within the
allowable green section and that no more than 3 in.
(7.6 cm) of the base hangs over the edge of the vehicle
seat (see pages 26-27).
9 Check that the child seat cannot be moved front to
back or side to side more than 1 in. (2.5 cm) at the belt
path. If the child seat is not secure, repeat installation
or use a different seating location.
9 Check that any excess tether webbing is contained
within your vehicle and secured in the elastic strap.
19