Impact Absorbing Chest Pads - Britax Essentials Emblem User Manual

BRITAX Child Safety, Inc.
3. Slide the end of the belly
pad over the foam pad on
the seat.
4. Pull the end of the belly
pad and buckle retainer
out of the slot in the cover
to remove.
5. Turn the buckle retainer
sideways and route the
buckle assembly out of
the belly pad.
Replacing the Harness Buckle
1. Turn the buckle retainer
sideways and route it
through the fabric strip on
the belly pad.
2. Route the belly pad and
buckle retainer through
buckle slot in the cover.
– Ensure that the buckle
is through the correct
cover slot for the buckle
position.
3. Slide the end of the belly
pad over the comfort
foam on the child seat.
4. Turn the buckle retainer
sideways and route it
through the front buckle
slot and then into the
desired buckle position
(see page 22).
– Ensure that the buckle
is in the correct buckle
position.
5. Replace the cover.
36
1
3
4
EMBLEM/ALLEGIANCE User Guide

Impact Absorbing Chest Pads

IMPORTANT: Impact absorbing chest pads are highly
recommended for forward-facing mode. Removal of
chest pads is optional for rear-facing mode to ensure a
snug fit for small infants.
Removing the Impact Absorbing Chest Pads
1. Loosen the harness.
a. Lift harness adjuster
lever.
b. Pull both harness
straps forward.
2. From the back of the
seat, unhook the harness
straps from the yoke.
3. Pull one harness strap
through the harness slot
to the front of the seat.
4. Route the harness strap
out of the comfort pad,
chest pad, and the chest
clip.
5. Reroute the harness
strap back through the
chest clip, ensuring that
the harness strap is not
twisted.
6. Repeat for other strap.
7. Route the harness straps
through the seat to the
back. Ensure that the
harness straps pass
through the harness
adjuster.
1b
1a
37