Incompatible Vehicle Seat Belts; Maintenance; Cover - Britax ADVOCATE CLICKTIGHT User Manual

Britax Child Safety, Inc.

Incompatible Vehicle Seat Belts

Vehicle seats and seat belts differ from vehicle to vehicle.
Refer to your vehicle owner's manual for specific information
about your vehicle seat belts and their use with child seats.
The following types of vehicle seat belts are NOT
compatible with this child seat. If any of the belt types
listed below are in the chosen seating position, choose
another vehicle seating position or check your vehicle
owner's manual for information on installing a car seat in
your vehicle.
Lap belts with a sewn-in
latch plate that have a
retractor that locks only
in case of a sudden stop�
Lap-shoulder belts with
top or bottom anchor
points on the vehicle door�
NOTE: This Britax car seat may not be compatible with
every inflatable lap-shoulder belt. See FAQs in the support
section of the Britax website (us.britax.com/faqs) for
additional instructions.
34
Lap belts forward of
the vehicle seat bight�
Motorized, automatic
vehicle seat belts�
ADVOCATE/BOULEVARD CLICKTIGHT User Guide

Maintenance

Cover

Removing the Cover
Never remove the buckle tongues from the harness.
They cannot be reattached after removal. If reassembled
incorrectly, the child seat may not perform as intended.
1. Loosen and unbuckle the
harness.
a. Push harness
release button.
b. Pull both harness
straps forward.
c. Unbuckle the
harness.
2. Open the chest clip.
a. Press tabs.
b. Pull apart.
3. Remove the comfort
pillow and comfort pads if
necessary.
4. Remove the belly pad and
buckle.
a. Open the
CLICKTIGHT and
remove the two
elastic loops on
the bottom of the
CLICKTIGHT.
b. Lift the front of
the seat cover
and pull over the
CLICKTIGHT bezel
to access the buckle
strap connection.
c. Remove the harness
buckle by turning
the buckle strap
sideways and routing
the retainer out of
the front buckle slot
in the child seat (see
page 39).
1b
1a
b
2b
a
2a
4a
4b
4c
35