Raymarine eci-100 Installation Instructions Manual page 42

LED indications
This product contains 2 diagnostic LEDs, one for the SeaTalk
connection. The LEDs for this product flash (blink) in set sequences which provides information on the
current status of the unit for diagnostics and troubleshooting purposes.
LED color SeaTalk ng LED code
Red
15s
Green
Green
9s
Red
Red
Red
Red
Note: If any other LED sequence other than described above is seen and persists please contact
Raymarine technical support.
Resetting the ECI-100
A specialist tool is required to reset the ECI-100,
contact Raymarine Product Support for further
information.
Your ECI-100 will need resetting if it has previously
been used on a different engine type.
42
Engine CAN bus LED
code State
Powering up
Normal operation
15s
DeviceNet powered
15s
on, SeaTalk
powered off
Network connected
9s
but no traffic (no
message received in
more than 5 seconds.
SeaTalk
on, DeviceNet Off.
General error (Device
connected wrong way
round
Software download in
progress (longer than
6 seconds.)
ng connection and one for the engine CAN bus
User action
None (normal power up takes
approximately 6 seconds.)
None
Power up SeaTalk
ng
ng powered
Swap over SeaTalk
connections
Wait for download to complete —
Multifunction display will indicate
when software download is
completed.
ng network.
ng and DeviceNet
ECI–100