Raymarine eci-100 Installation Instructions Manual page 41

ECI-100 troubleshooting
Aspects of the installation can cause problems with the data shared between connected equipment. Such
problems, their possible causes and solutions are described here.
Missing or no engine data is displayed on MFD
Possible causes
ECI-100 not powered or not powered
correctly.
Engine or engine data item not supported
MFD not configured with correct number of
engines
Engine identification wizard not completed
(LightHouse TM MFD)
Legacy MFDs may not support all PGNs
MFD software not compatible with ECI-100
ECI-100 running older software
ECI-100 is in instancing mode. The ECI-100
will not output data until it has finished
instancing the engines.
Engine configuration requires multiple
ECI-100 units.
Engine not compatible with ECI-100
Incompatible 3rd party Engine Gateway
present on system
ECI-100 has previously been used on a
system with a different engine type.
System checks and troubleshooting
Possible solutions
Refer to the 'Power up troubleshooting' section for details.
• Ensure that the SeaTalk
• Ensure that the engine CAN bus is powered on.
Note: The ECI-100 requires power from both the SeaTalk
the Engine CAN bus.
Only the specified data items on compatible engines can be displayed.
Re-configure MFD to ensure correct number of engines has been selected:
• Legacy MFDs — From the Engine monitor / application select: Menu > Panel
Setup Menu > Number of Engines
• LightHouse TM powered MFDs — From the Homescreen select: Customize
> Boat Details > Num. of Engines
Complete the Engine identification wizard.
Upgrade MFD to an a, c, e, eS or gS Series to ensure
Upgrade MFD software to the latest version available from the website.
Upgrade ECI-100 software to the latest version available from the website.
• Wait until engine instancing has completed.
• Engine instancing may be required, please contact your engine dealer.
On some, multiple engine configurations, where each engine is on its own CAN
bus you must use 1 ECI-100 unit for each engine CAN bus.
Check the Raymarine website for a list of compatible engines.
Remove 3rd party Engine Gateway and try again.
• Contact Technical Support for information on how to get your ECI-100 reset.
• Swap out ECI-100 for new unit.
ng®
backbone is correctly powered.
ng® backbone and
41