Mounting The Unit - Raymarine eci-100 Installation Instructions Manual

5.1 Mounting the unit

The ECI is designed to be surface mounted.
Before mounting the unit ensure that you have:
• Identified the routes that the cables will take.
1. Switch off the vessel's power supply.
2. Check the selected location for the unit, a clear,
flat area is required, which is safe to have screws
fitted to.
3. Position the converter against the selected
location and mark the surface through the
converter's mounting holes.
4. Using an appropriate size drill bit, drill 2 holes at
the marked locations.
5. Position the converter so that the mounting holes
of the unit line up with the drilled holes in the
mounting surface.
6. Using the fixings provided secure the converter
to the mounting surface. Do NOT overtighten
the fixings.
7. Connect the SeaTalk
DeviceNet adaptor cable to the unit.
8. Ensure the CAN bus connector of the DeviceNet
adaptor cable is plugged into the relevant point
on the engine's CAN bus.
9. Switch the vessel's power supply back on and
check system.
32
ng spur cable and the
D12973-1
ECI–100