Raymarine eci-100 Installation Instructions Manual page 18

12 V dc
5
ng
SeaTalk
ng
SeaTalk
Note: The illustration above shows the various
products that can be connected in a typical system.
For information on how to connect the products,
refer to the Chapter 4 Cables and connections
section. For information on available cables and
accessories, refer to the
accessories section.
Item Description
1 Multifunction display
2 Vessel engines (Connection to engine's CAN bus)
3 Engine specific adaptor cables
4 ECI units
5
SeaTalk ng 5–way block
Example: expanded system
In the example below the unit is used as both
engine interface and steering control interface
simultaneously.
12 V dc
ng
SeaTalk
6
5
9
5
ng
SeaTalk
18
1
2
3
4
2
3
4
Chapter 10 Spares and
1
2
3
4
7 8
Note: The illustration above shows the various
products that can be connected in a typical system.
For information on how to connect the products,
refer to the Chapter 4 Cables and connections
section. For information on available cables and
accessories, refer to the
accessories section.
Item Description
1 Multifunction display
2 Vessel engine(s) and steering (Connection to
engine CAN bus)
3 Engine-specific adaptor cable
4
ECI unit
5 SeaTalk
6 EV2 — Evolution
D12970-1
7 SeaTalk
8 SeaTalk
9 SeaTalk
SeaTalk
Typical system — legacy MFDs
Example: basic system — engine interface only
12 V dc
5
ng
SeaTalk
1. Legacy MFD (e.g. E-Series Widescreen).
2. Vessel engine(s), connected to engine CAN bus
(e.g. J1939).
3. Engine-specific adaptor cable.
4. ECI unit.
5. SeaTalk ng 5-way block.
D12971-2
Chapter 10 Spares and
ng 5–way block
TM autopilot
ng Pilot control head
ng instrument display
ng spur cable connection between the
ng bus and the EV2's SeaTalk
1
2
3
4
ng connector.
D13056-1
ECI–100