How To Change The Printer Paper - Maico MI 34 Operating Instructions Manual

Operating Instructions MI 34 / MI 34 H

15 How to change the printer paper

Open the printer at the right side of the housing by pulling up the printer
cover using its finger mould in front.
Remove the printer cover .
Remove the empty paper roll.
Place the new paper roll in the paper compartment in such a way that the
paper ascends from the lower part of the paper roll.
Pull the blue lever, which is located on the right front of the printer, into its
forward position.
The paper must roll from the bottom because it is coated on one side only.
If it is inserted wrongly, no printout is visible!
Gently insert the paper end between the rubber roll and the black plastic
part at the rear of the printer.
Transport the printer paper until it appears from the upper part of the
rubber roll. Pull then the paper end app. 10 to 15 cm.
Push the blue lever into its backward position.
Guide the paper end through the paper slot of the printer cover .
Close the printer cover by putting the two guide rails at the end of the
printer cover into the appropriate slot of the paper compartment of the
housing of MI 34. Press the front of the printer cover down until it
fastens.
The instrument is now ready to print.
51
GEBAmi34e.11a.docx 850 232/14 08/11