Installing The System Into A Rack; Installing The Inner Rack Rails - Supermicro SSG-937R-E2CJB User Manual

SSG-937R-E2CJB User's Manual
2-4

Installing the System into a Rack

This section provides information on installing the SSG-937R-E2CJB into a rack
unit with the quick-release rails provided. There are a variety of rack units on the
market, which may mean the assembly procedure will differ slightly. You should
also refer to the installation instructions that came with the rack unit you are using.

Installing the Inner Rack Rails

Installing the Inner Rails
1. Extend the inner rail toward the front of the rail assembly as far as possible,
then depress the locking tab to pull it completely out.
2. Place the inner rail on the side of the chassis aligning the hooks of the chas-
sis with the rail extension holes.
3. Slide the extension toward the front of the chassis.
4. You may secure the chassis with screws if desired.
5. Repeat steps 1-3 for the other inner rail.
Stability Hazard. The rack stabilizing mechanism must be in place, or the
rack must be bolted to the floor before you slide the unit out for servicing.
Failure to stabilize the rack can cause the rack to tip over.
Figure 2-1. Installing the Inner Rack Rails
1
3
2-4
1
2