Dns1Ip - Cisco ATA 188 Administrator's Manual

Chapter 5 Parameters and Defaults
•
•
•
•
Examples
The following examples are recommended values for the CallerID Method parameter:
•
•
•
Value Type
Bitmap
Default
0x00019e60
Voice Configuration Menu Access Code
316

DNS1IP

Description
This parameter is for setting the primary domain name server (DNS) IP address, if the DHCP server does
not provide one. If DHCP provides DNS1IP (and if it is non-zero), this parameter overwrites the
DHCP-supplied value. You cannot specify a port parameter. The Cisco ATA uses the default DNS port
only.
Value Type
IP address
Default
0.0.0.0
Voice Configuration Menu Access Code
916
Related Parameter
DHCP, page 5-6
Ol-3141-01
Bits 3-6—These bits are for the Start digit (valid values are 12 for "A," 13 for "B," 14 for "C," and
15 for "D.").
Bits 7-10—These bits are for the End digit (valid values are 11 for "#," 12 for "A," 13 for "B," 14
for "C," and 15 for "D.").
Bits 11—This bit is for setting polarity reversal before and after the Caller ID signal (value of 0/1
disables/enables polarity reversal).
Bits 12-16—These bits are for the maximum number of digits in the phone number (valid values are
1 to 20).
Sweden=0x0ff61
Denmark=0x0fde1
USA=0x19e60
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SCCP)
Operating Parameters
5-15