Lbrcodec - Cisco ATA 188 Administrator's Manual

Chapter 5 Parameters and Defaults
•
•
•
•
•
•
•
•

LBRCodec

Description
This parameter is used for selecting the low-bit-rate codec. The following values are valid:
•
•
If LBRCodec=0, then both Cisco ATA FXS ports can operate with the following codecs:
•
•
•
•
If LBRCodec=3, check the setting of bit 21 in the ConnectMode parameter (see the
section on page
If LBRCodec=3, then the Phone 1 FXS port can operate with the following codecs:
•
•
•
•
•
If LBRCodec=3, then the Phone 2 FXS port can operate with the following codecs:
•
•
•
•
Value Type
Integer
Range
0 or 3
Ol-3141-01
CallerIdMethod, page 5-14
DNS1IP, page 5-15
DNS2IP, page 5-16
Domain, page 5-16
NumTxFrames, page 5-17
UDPTOS, page 5-17
OpFlags, page 5-17
VLANSetting, page 5-18
0—Select G.723.1 as the low-bit-rate codec (available only for connections 0 and 2).
3—Select G.729A as the low-bit-rate codec (available only for connection 0).
Number of codecs=3
Codec[0]=G.711µ -law
Codec[1]=G.711A-law
Codec[2]=G.723.1
5-13) to determine if G.729 is enabled for the Phone 1 or Phone 2 FXS port.
Number of codecs=4
Codec[0]=G.711µ-law
Codec[1]=G.711A-law
Codec[2]=G.729 (only if Bit 21 of the ConnectMode parameter is set to 0)
Codec[3]=G.729A
Number of codecs=3
Codec[0]=G.711µ-law
Codec[1]=G.711A-law
Codec[2]=G.729 (only if Bit 21 of the ConnectMode parameter is set to 1)
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SCCP)
Operating Parameters
"ConnectMode"
5-11