Pre-Installation Checklist; Safety And Recommendations - Envirovent energiSava 200 Installation Manual

Safety
Be sure to have read and understood these
instructions before beginning the installation
process.
PRE-INSTALLATION CHECK LIST
Make sure that the unit can physically fit in to
the desired location.
The energiSava® 200 unit should be situated so
that access for maintenance or replacement
of parts is possible. Make the ductwork runs as
short as possible. Having the most direct route
and using as few bends as possible will reduce
air resistance and improve the efficiency of the
unit
1
energiSava® 200

SAFETY AND RECOMMENDATIONS

•
All wiring must comply with Building
Regulations and the current I.E.E. Wiring
Regulations (BS7671) or the equivalent
standards for your country. The final
installation should be examined and tested
by a qualified electrician.
•
The appliance is to be supplied through a
residual current device (RCD) having a rated
residual operating current not exceeding
30mA.
•
Precautions must be taken to avoid the back-
flow of gases into the dwelling from the open
flue of gas or other fuel-burning appliances.
•
Make sure the mains supply complies with
the rating label for voltage, frequency and
phase.
•
This appliance can be used by children
aged from 8 years and above and
persons with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand
the hazards involved. Children shall not
play with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
•
The appliance is considered suitable for use
in countries having a warm damp equable
climate, but may also be used in other
countries.
SHOULD YOU ENCOUNTER ANY PROBLEMS
INSTALLING THIS UNIT, CALL US ON:
0345 27 27 810