Envirovent energiSava 200 Installation Manual page 14

Commissioning Part 2
Boost Control Versions
The energiSava® 200 operates continuously on
'Normal' setting to ensure the home is ventilated at
the appropriate level although you can boost the
system via the remote control switch.
To view the current status of your unit press any
button once. If in trickle the unit can be boosted by
pressing the boost button, the boost LED will light
and the unit will go to boost for 20 minutes. If in
boost the unit can be set back to trickle by pressing
trickle.
To pair additional remote control switches
(wireless units only)
1. Turn the unit off at the isolation point.
2. Restore power; for 20 seconds from restart the
unit will be in pairing mode.
3. Press any button once within the 20 seconds
and the control will pair to the unit.
4. Successful pairing is indicated by a green light
on the control.
Trickle Boost Summer bypass
(normal)
Note: All flash indicates a unit fault
13
energiSava® 200
Batteries
When the battery requires changing, unclip the
switch front cover. The batteries are located on the
back of the cover. Battery type - AAA x 2.
Ensure that the new batteries are inserted with the
correct polarity and that the exhausted batteries
are removed and safely disposed of. If the control is
stored unused for a long period, it is recommended
batteries are removed.
App Control Versions
For App control versions see the separate App
instruction booklet.
App controlled units allow a large degree of control
over the unit via a smart device.
Flashing =
Check filter. Press
for 12 seconds to
reset filter once
filter maintenance
is complete.
(Pg 15-16)
For SSID and password information, see the back
page of the instructions.
SHOULD YOU ENCOUNTER ANY PROBLEMS
INSTALLING THIS UNIT, CALL US ON:
0345 27 27 810