SSV Works RZ3-FKP65 Installation Manual

SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: 818-991-1778 | Fax: 866-293-6751
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects
in material or workmanship. All SSV Works Electronics are covered by a limited 1 year
warranty against defects in material or workmanship. All SSV Works Speakers are
covered by a limited 1 year warranty against defects in material or workmanship. Labor
for replacement of defective components is not covered. Contact SSV Works for further
warranty information.
TOOLS NEEDED FOR INSTALLATION
- Wire Crimpers
- Wire Strippers
- T-40 Torx Driver
- 7/16" Open End or Socket
- 5/32 Allen Wrench
PARTS LIST IMAGES
1. RZ3-FKP65 Enclosures
(1 pair)
INSTALLATION NOTES
The use of a thread locker is recommended on all screws to prevent loosening due to vibration. If installing an SSV Works RZ3-GBSB10 Glove
Box subwoofer enclosure, install the subwoofer enclosure first, then complete the passenger side kick panel installation. The removal of the
fender flare is not required; however it will make the installation easier.
- Drill with 1/4" and 1/8"
Drill bit
- #2 Phillips Screwdriver
- Utility Knife
- Scribe or Marker
2. 1/4 x 20 Allen Bolt x 6
RZR XP1000 & 2015+ RZR900
6.5" Speaker Front Kick Panels
Please read and understand these
!
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
PARTS LIST
1. RZ3-FKP65-U Enclosures (1 pair)
2. 1/4" x 20 Allen Bolt x 6
3. 1/4" Washers x 6
RZ3-FKP65
3. 1/4" Washers x 6
4. 7/16" Nut x 6
4. 7/16" Nut x 6