Fujitsu PRIMERGY CX400 M4 Operating Manual page 43

Ê Move the left rail towards the front side (4) while holding the positioning clip
(3). The mounting aid must lock in the corresponding hole.
Ê Release the positioning clip (5) after the designated position is reached.
Ê Repeat this procedure to install the right rail.
Installing the server enclosure into the rack
V
CAUTION!
At least two people are needed to position the server on the rack rails.
(For Japan, please refer to " 安全上のご注意 ".)
Additionally, a lifter is required in the following cases:
– The server weighs more than 50 kg.
– The server weighs more than 21 kg and is to be installed above the
height of 25 U.
CX400 M4
For configurations below 32 kg:
At least two people are needed to lift the server
into the rack cabinet.
For configurations below 55 kg:
At least three people are needed to lift the server
into the rack cabinet.
For configurations above 55 kg:
At least four people are needed to lift the server
into the rack cabinet.
Operating Manual
Hardware installation
43