Normal Operation Mode - Hayward Super II Installation And Operating Instruction Manual

MOTOR INTERFACE USER GUIDE

Normal Operation Mode:

Press Button:
- For Low Speed
(LED will remain solidly lit when selected)
- For Medium Speed
(LED will remain solidly lit when selected)
- For High Speed
(LED will remain solidly lit when selected)
- Stop Button
(Power LED will flash when the pump is in standby mode)
Adjusting The Set Point Of Each Speed:
Press and hold
,
begins to flash. Once flashing the selected speed has entered into the Adjustable Set Point Mode.
To reset the speeds to the factory default settings hold down all three (3) buttons untill all three LED's are solidly lit.
Press Button:
- To decrease speed by 100rpm increments with 1000rpm as the minimum limit for LOW, MED, and HIGH.
- To save the current speed setting and return to Normal Operation Mode hold the button down for 5 seconds.
- To increase speed by 100rpm increments with 2850rpm as the maximum limit for LOW, MED, and HIGH.
- Will cancel the change and revert back to the original speed and return to Normal Operation Mode.
Note:
- If power is removed , motor will return to the last speed that was selected when power is restored.
- If power is removed then restored the motor will remember what it's on/off state was.
- If there is a fault, the fault LED will blink a sequence code. Count the blinks and contact service agent.
Super II Variable Speed Pump
, or for aproximatly three (3) seconds or untill the LED of the selected speed
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Super II Variable Speed Pump