Figure 8 Required Order Of Battery Cable Hardware; Figure 9 Battery Terminal Covers - OutBack Power FXR2012A Installation Manual

To install DC cables and hardware:
1. Install all DC cables.
2. Do not install hardware in a different order from Figure 8. The battery cable lug should be the
first item installed on the stud. It should make solid contact with the mounting surface.
3. Do not close the main DC disconnect until wiring is complete and the system is prepared
for commissioning.
13 mm Nut
Flat Washer
Mounting Surface
Insulator
Figure 8
4. Install the battery terminal covers. These are made of stiff plastic with a snap-on design.
If it is necessary to remove the covers,
remove carefully using a flat screwdriver.
Insert the screwdriver into the slot on the
side of each cover and unsnap the cover.
900-0166-01-01 Rev A
Required Order of Battery Cable Hardware
CAUTION: Fire Hazard
Never install extra washers or hardware between the mounting surface and the battery
cable lug. The decreased surface area can build up heat.
REMOVAL SLOT
Figure 9 Battery Terminal Covers
Commissioning
M8 x 1.25 Stud
Lock Washer
Battery Cable Lug
21