Hach HQ430d Basic User Manual page 13

View stored data
The data log contains sample, calibration and check standard data. The most recent data point in the
data log is tagged as Data Point 001.
1. Push the key.
2. Select View Data Log to view the stored data. The most recent data point is shown. The top of
the screen shows whether the data is from a sample reading, a calibration or a check standard.
Push the key to view the next most recent data point.
Option
Reading Log
Calibration Log
Check Standard Log Check Standard Log—shows check standard measurements. Select Details to view
View stored probe data
Make sure that a probe is connected to the meter. If two probes are connected, select the
appropriate probe when prompted.
1. To view the calibration data that is stored in a probe, push the
Data. The current calibration and calibration history for the probe can be viewed.
Option
View Current
Calibration
View Calibration
History
Print stored data
The meter must connect to AC power to start the USB connection. Make sure that the connection to
AC power is made before the meter is powered on.
All data can be sent to a printer. Compatible printers should support a minimum of 72 columns of
data, be capable of printing up to 500 continuous data-stream events in 1, 2 and 3 lines of text and
fully support code page 437 and code page 850.
1. Turn off the meter. Make sure that the meter is connected to AC power. Refer to
power on page 6.
2. Connect the printer to the meter with a USB cable type A. Refer to
3. Turn on the meter.
4. Push the key.
5. Select Send Data Log. Wait for the display to show "Transfer Complete" and wait for the printer to
stop printing. Disconnect the printer.
Description
Reading Log—shows sample measurements including the time, date, operator and
sample ID. Select Details to view the associated calibration data.
Calibration Log—shows calibration data. Select Details to view additional information
about the calibration.
the calibration data that was associated with the measurement.
Description
The current calibration information shows the calibration details for the most recent
calibration. If the probe has not been calibrated by the user, the factory calibration
data is shown.
The calibration history shows a list of the times when the probe was calibrated.
Select a date and time to view a summary of the calibration data.
key and select View Probe
Connect to AC
Figure 9.
English 13