Installation Of 3D Filter Assembly - Sony LKRA-009 Installation Manual

2-8-3. Installation of 3D Filter Assembly

This section describes the installation procedure of 3D filter assembly using the illustration of the 3D
filter that is opened/closed in the left direction.
1. Pull the lock pin in the direction of the arrow A, then pull the support frame 3 in the direction of the
arrow B.
2. While pushing the two clips of the slide rails in the direction of the arrow A, pull out the support
frame 3 in the direction of the arrow B.
Digital Cinema Dual System
B
Support frame 3
A
Lock pin
Lock pin
Clip
A
A
Clip
Support frame 3
B
2-27 (E)