Installation Of Server; Rack Mounting - Sony LKRA-009 Installation Manual

The procedures for the installation of server, connection with projector and power connection are described.
The Hard Disk Drives (HDD) are installed in the server. The HDD is a precision, delicate part. The causes
such as shock, vibration and electro static discharge (ESD) to the server, and the conditions of temperature
and humidity may damage HDD or its data. When installing the server, carefully read the precautions in
"Safety Regulations" supplied with the product and perform the procedure with caution.
HDD Upgrade Kit LKRA-009
For the installation of LKRA-009, refer to the Service Manual (1st Edition Revised 3 or later) in the
Digital Cinema Projector Package SRX-R515P/R510P.

3-1. Installation of Server

There are following two procedures for the installation of server.
. Mounting in the rack
. Placing on the pedestal

3-1-1. Rack Mounting

The procedure for mounting the server in the 19-inch standard rack is described here. Perform the instal-
lation of the device in the rack correctly according to the caution and procedure described below.
w
. To prevent the rack from falling or moving, fix the rack on a flat and steady floor and the like using
bolts or others.
If the rack falls due to the weight of the equipment, it may cause death or serious injury.
. Be sure to use the specified rack mount kit.
If not, injury may result and the equipment may fall due to insufficient strength.
. After rack mounting, be sure to tighten the screws on the rack angle and fix the server in the rack.
If the screws on the rack angle are not tightened, the server may slip from the rack and fall, causing
injury.
c
When mounting the server in the rack, note the following:
. Be sure to mount in the rack with two persons or more.
. Be careful not to catch your fingers or hands in the rack mount rail or others.
. Mount in the rack in a stable position.
n
To reduce the temperature rise inside the server, keep at least 4 cm in the front and at least 10 cm in the
rear between the rack and server.
Required parts
. Screw for rack mounting : 4 pcs
t
The screws are not supplied with the product. Prepare the screws that match the rack.
Digital Cinema Dual System
Section 3
Installation of Server
3-1 (E)