Turning Off The Lamps Individually - Sony LKRA-009 Installation Manual

5-14-10. Turning Off the Lamps Individually

The lamps can be turned off individually when the projector is power-on state (lamps are lit). This func-
tion is used temporarily for the test and so forth.
Even if the projector is made standby state or the lamps are turned off in the state that some lamps have
been turned off, all lamps light up when the next time the power is turned on. (Prevention of forgetting to
turn on the lamps)
Even if the Lighting Pattern is set to 5 or less (SRX-R515P/R515), when you tap "ON" of this screen
from the standby or lamp-off state, all lamps (six lamps for SRX-R515P/R515) will be lit. When you start
up the projector using "Power-ON", the lamps corresponding to the number of lamps stored in the memo-
ry will be lit.
1. Tap the "Configuration" tab.
2. Tap [Projector|$2D%] → [Adjust|Lamp].
The Adjust Lamp screen is displayed.
[Projector|$2D%]
Screen example
[Adjust|Lamp]
3. Tap [OFF] of the lamp that you want to turn it off.
If you want to turn on the lamp again, tap [ON] of the lamp that was turned off.
n
Turn on the same number of lamps of the sub-projector as that of the main projector.
5-66 (E)
Configuration tab
Digital Cinema Dual System