Delta 50-767 Instruction Manual page 9

ATTACHING REAR BLOWER
HOUSING SUPPORT
1. Place base frame on side.
2. Align Rear blower housing support with
through holes.
3. Insert M8 hex socket head screw through
base support and base frame as shown.
4. Place M8 flat washer and M8 lock nut on
bottom side (Fig 3).
5. Tighten lock nut.
6. Repeat for other side.
ATTACHING FRONT SUPPORT
ASSEMBLY
1. Place unit on its side.
2. Align front support assembly with through
holes at front of base frame.
3. Insert M8 hex socket head screw through
hole in base frame and thread into front
support (Fig 4).
4. Tighten screw.
5. Repeat on other side.
ATTACHING REAR STAND CROSS
SUPPORT
1. Place unit upright.
2. Align rear stand cross support with through
hole on rear blower housing support.
3. Insert M6 hex socket head screw through
rear base support hole and thread into
cross support (Fig 5).
4. Tighten screw.
5. Repeat on other side.
ASSEMBLY (continued)
9
FIGURE 3
FIGURE 4
FIGURE 5