Initial Setup For Tztl12F/Tztl15F - Furuno DRS6A-NXT Installation Manual

1. Select a range between 0.125 and 0.25 NM and set the mode to "head up".
You can select a range by a pinch action. The range and range ring interval ap-
pear at the bottom left of the screen.
Zoom in
For TZTBB, you can also control the range in the operation as follows. Tap the
radar scale box at the bottom left-hand corner of the screen to display the slider
bar. Drag the circle icon to set the range scale.
Tap the area circled in the dashed line to
display the slider bar.
Note: You can switch between transmit and
stand-by by tapping the right side of the
radar scale box.
2. Turn the vessel's bow toward a target.
3. Press the Home key (or tap the Home icon), then select [Menu] icon, [Radar], and
[Antenna Heading Align] in that order to show the numeric software keyboard.
4. Key in the offset value so that the target is at the very top of the screen (setting
range: +/- 0° to 180°, +: clockwise direction, -: counterclockwise direction), then
tap [Save].
5. Confirm that the target echo is displayed at correct bearing on the screen.
2.2

Initial Setup for TZTL12F/TZTL15F

1. Tap the [Home] icon to show the home screen and display mode settings.
2. Tap [Radar] from the [Settings] menu.
3. Tap [Radar Source], then select the appropriate antenna unit.
Note: If the antenna unit is connected but does not appear in the [Radar Source]
list, close the list and open it again. The name of the antenna unit should appear
with a check mark, as in the example below.
4. Drag the [Radar] menu display the menu item [Radar Initial Setup], then tap
[Radar Initial Setup].
5. Referring to the tables below, set up the radar.
Zoom out
Pinch action
18
Range
1
Range indications
Zoom in
Current
range 4NM
Zoom out
RDxxxxxx - DRS6A-NXT
Display example for DRS6A-NXT
2. INITIAL SETUP
Range ring interval
Slider bar
Drag the circle icon to
set the range scale.