Initial Setup For Tzt9/Tzt14/Tztbb - Furuno DRS6A-NXT Installation Manual

2.1

Initial Setup for TZT9/TZT14/TZTBB

1. Press the Home key (or tap the Home icon).
2. Select [Menu] on the menu icon bar to open the main menu.
3. Select [Radar].
4. Select [Radar Source] on the [Menu Radar] sub menus, then select the radar type
connected.
Note: If the antenna unit is connect-
ed but does not appear in the [Ra-
dar Source] list, close the list and
open it again. The name of the an-
tenna unit should appear with a
check mark, as in the example to
the right.
5. Drag the [Menu Radar] sub menus
to find the menu item [Radar Initial
Setup].
Title
6. Set the items referring to the table shown below
Menu item
[Antenna Rotation]
[Antenna Heading Align]
[Main Bang Suppression]
[Enable Sector Blanking]/
[Enable Sector Blanking2]
[Antenna Height]
Menu Radar (Radar Initial Setup)
Select the antenna rotation speed.
See "How to align the antenna heading" on page 17.
If main bang appears at the screen center, slide the circle
icon, while watching the radar echo on the left-side of the
display, until the main bang disappears.
Up to two sectors may be selected for blanking (no trans-
mission). Select [ON] to enable this feature. Set the start
and end angles (0° to 359°).
Select the height of the antenna above the waterline.
16
2. INITIAL SETUP
RDxxxxxx - DRS6A-NXT
RDxxxxxx - DRS6A-NXT
Display example
Description