Furuno DRS6A-NXT Installation Manual page 20

1. INSTALLATION AND WIRING
6. Secure the ground wire to the ship's ground.
The figures shown below are examples for grounding.
Ex.1
Ground wire
7. Secure the cable assembly to the cable cover with the cable ties (local supply) as
shown in the figure below.
If the cable is run through a If the cable is run through a
radar mast and the bottom of the radar mast and the bottom of the
unit, fix the cable to this cable unit, fix the cable to this cable
clamp. clamp.
8. Reattach the cable cover.
9. Connect the LAN connector of the cable assembly to a LAN port on the FURUNO
Multi Function Display or Ethernet HUB.
Note 1: Do not connect the LAN connector to on-board LAN.
Ethernet HUB
FURUNO Multi Function Display
Marine sealant
Hex. bolt
Flat washer
Flat washer
Spring washer
Hex. nut
Fix the cable to this cable Fix the cable to this cable
clamp, using a cable tie. clamp, using a cable tie.
Power/LAN cable Power/LAN cable
Cable cover - bottom view
OR
Ex.2
Marine sealant
Ground wire
Cable assembly Cable assembly
LAN connector
13
Hex. nut
Spring washer
Flat washer
Hex. nut
Weld here.
Ground wire from Ground wire from
the ship's ground the ship's ground
Ground wire from Ground wire from
the antenna unit the antenna unit
Cable assembly