Table of Contents
Advertisement
> PTZ camera connection and settings
•
PAN/TILT camera setup
1. Connect the control terminal (RS-485) between camera and DVR.
2. Set the camera ID independently among 1-99.
3. Turn on the power to check whether the DVR displays the video image.
Video In
DVR
Note
The connection could be different by the PTZ model so, please refer to the product manual.
•
DVR setup
1. Press the SET UP button on the front panel to go to PTZ on the CHANNEL menu.
2. As shown at the below, configure PROTOCOL, ID, BAUD on the channel with PTZ installed.
Note
Baud configuration
To configure RS-485 Baud RATE as PTZ transmission speed for each channel, Please refer to PTZ
specification.
50
POWER
ID Setup
Video Out
PAN/TILT camera
Advertisement
Table of Contents
