Mounting The Proto-Sound 3.0 Board - M.T.H. Proto-Sound 3.0 Installation Manual

Mounting The Proto-Sound 3.0 Board

- Remove the Proto-Sound 3.0 Board
(A) from the sealed anti-static bag
- Verify Proto-Sound 3.0 board is
securely inserted into its plastic
mounting bracket.
NOTE: If you are not a
participating MTH
Authorized Service Center
there is NO warranty once
the bag is opened.
NOTE: Use ESD safe work
area and procedures when
handling the Proto-Sound
3.0 board.
- Remove the speaker (H) from the
protective packaging.
NOTE: Be careful not to damage the
speaker cone
- Place the Proto-Sound 3.0
board/plastic mounting bracket (A)
on the chassis to verify the best
location to mount the plastic
mounting bracket and the metal heat
sink bracket (AA) to the chassis.
Proto-Sound 3.0 Upgrade Kit Installation Guide - Diesel/Electric
Make sure the Proto-Sound 3.0 board is
firmly inserted into the plastic mounting
bracket. If not, gently push the board into the
bracket until fully "captured" by the bracket.
DO NOT REMOVE THE BOARD FROM
THE BRACKET.
Place the components on the chassis floor
in the best position given the space.
11