Video Settings - Fujitsu KVM1116Q User Manual

Video Settings

Clicking the Hammer icon on the Control Panel brings up the Video Settings dialog box. Adjust the
placement and picture quality of the remote screen on your monitor with these options.
Options
Screen Position
Auto-Sync
RGB
Gamma
Network Type
Video Quality
Enable Refresh
Transparency
Color Depth Control
Gamma Adjustment.
Gamma function of the Video Adjustment dialog box.
• Under Basic configuration, there are ten preset and four user-defined levels to choose from.
Choose the most suitable one from the list.
• For greater control, click the Advanced button to open the dialog box
• Click and drag the diagonal line at as many points as needed for the display output desired.
• Click Save As to save up to four user-defined configurations. Saved configurations can be
opened from the list box.
• Click Reset to abandon any changes and return the gamma line to its original position.
• Click OK to save your changes and close the dialog box.
• Click Cancel to abandon your changes and close the dialog box.
NOTE:
For best results, change the gamma while viewing a remote server.
28
Usage
Adjust the horizontal and vertical position of the remote server window by clicking the Arrow
buttons.
Click to have the vertical and horizontal offset values of the remote screen detected and
automatically synchronized with the local screen.
NOTE: 1. If the local and remote mouse pointers are out of sync, in most cases, performing
this function will bring them back into sync.
2. This function works best with a bright screen.
3. If the results are unsatisfactory, use the Screen Position arrows to position the
remote display manually.
Drag the slider bars to adjust the RGB (Red, Green, Blue) values. When an RGB value is
increased, the RGB component of the image is correspondingly increased. If you enable
Set to Grayscale, the remote video display is changed to grayscale.
This section allows you to adjust the video display's gamma level.
Select the type of internet connection that the local client computer uses. The switch will
use that selection to automatically adjust the Video Quality settings to optimize the quality
of the video display.
Since network conditions vary, if none of the pre-set choices work well, select Customize
and use the Video Quality slider bars to adjust the settings to suit your conditions.
Drag the slider bar to adjust the overall Video Quality. The larger the value, the clearer the
picture and the more video data goes through the network. Depending on the network
bandwidth.
Select Enable Refresh and enter a number from 1 through 99. The KVM switch will refresh
the screen at the interval specified. This feature is disabled by default. Click to put a check
mark in the box next to Enable Refresh to use this feature.
NOTE: 1. The switch starts counting the time interval when mouse movement stops.
2. Enabling this feature increases the volume of video data transmitted over the
network. The lower the number specified, the more often the video data is
transmitted.
Adjusts toolbar transparency when the GUI hotkey is invoked. Slide the bar until the display
in the example window is satisfactory.
This setting determines the richness of the video display by adjusting the amount of color
information.
If it is necessary to correct the gamma level for the remote video display, use the