Connection Setup Example (Windows 7) - Fujitsu KVM1116Q User Manual

Basic Setup.
The KVM switch can be accessed through its RS-232 port using a PPP dial-in
connection:
1. Set up your the KVM switch configuration to match the diagram:
Remote
User
2. From your client computer, use your modem dial-in program to dial into the KVM switch's
modem.
NOTE:
If you don't know the KVM switch modem's serial parameters, get them from the KVM
swich administrator.
3. Once a connection is established, open your browser, and specify 192.168.192.1 in the URL
box.
4. The default username and password are blank.
5. For the modem session, the KVM switch has an IP address of 192.168.192.1;
the user side has an IP address of 192.168.192.101.
6. From here, operation is the same as if you had logged in from a browser or with the AP
programs.

Connection Setup Example (Windows 7)

To set up a dial-in connection to the KVM switch under Windows 7:
1. From the Start menu, select Control Panel > Network and Internet > Network and Sharing Center
2. Select Set up a new connection or network.
3. In the Network Connection Type dialog box, select Connect to the network at my workplace,
then click Next.
4. In the Network Connection dialog box, select Dial-up connection.
5. In the Phone Number to dial dialog box, enter the phone number of the modem connected to the
KVM switch (include country and area codes, if necessary).
6. In the Connection Name dialog box, key in a name for the connection
(Example: TPE-KVM2132P-01), then click Next.
7. Enter the username and password, click on Connect.
8. Start > Control Panel > Network and Sharing Center > Change adapter settings
9. Right-click on the connection you created the connection.
90
LAN 2 PDU 2
LAN 1 PDU 1
Modem
Adapter
Modem
Phone Line