Nomadix AG 2400 Quick Start Manual page 3

Step 1a: Static WAN IP Configuration
Accept static as the default configuration mode and enter the following mandatory settings
shown in Figure 2.
Configuring minimal WAN interface connectivity parameters:
Configuration Mode
IP Address
Subnet Mask
Gateway IP
WAN 802.1Q tagging
VLAN ID
DNS Domain Name
DNS Server 1
DNS Server 2
DNS Server 3
Figure 2: Initial WAN port settings.
A WAN port summary page will then be displayed as shown in Figure 3.
Port Name
Port Role
Configuration Mode
IP Address
Subnet Mask
Gateway IP
WAN 802.1Q tagging
VLAN ID
DNS Domain Name
DNS Server 1
DNS Server 2
DNS Server 3
Additional NAT IP addresses
show all
show interface <name>
modify interface <name> - Modify a single WAN Interface configuration
Type b to go back, <esc> to abort, ? for help.
Ethernet port/WAN interface configuration>
Figure 3: WAN port static IP configuration summary page.
If everything is correct in the summary, type b[ack] to return to the previous menu, and proceed
to Step 2 to enter the location information.
Otherwise, select an option from the Ethernet port configuration menu to display or make
changes to the WAN port settings. When finished with the settings, type b[ack] to return to the
previous menu and go to Step 2.
[static ] (static, dhcp, pppoe) :
[10.0.0.10 ] : Your WAN IP address
[255.255.255.0 ] : Your subnet mask
[10.0.0.1 ] : Your gateway IP address
[Disabled ] :
[1 ] :
[nomadix.com ] :
[0.0.0.2 ] : Your primary DNS IP
[0.0.0.0 ] :
[0.0.0.0 ] :
: WAN
: wanIf
: static
: Your IP address
: Your subnet mask
: Your gateway IP addrss
: Disabled
: 1
: nomadix.com
: Your primary DNS IP address
:
: 0.0.0.0
: Disabled
- Show all WAN Interface configuration
- Show a single WAN Interface configuration
3 02.11.2016