Nomadix AG 2400 Quick Start Manual page 2

b. Subscriber-side Ethernet Connection:
i. Connect a cross-over Ethernet cable between the product's Eth1 port and your
ii. See Figure 10 and Table 4 on Page 8 for Ethernet LED status.
iii. Setup a SSH client to establish a SSH session to communicate with the NSE
IP Address
172.30.30.173
Table 2: Administrative IP address.
5. Power up your computer and turn on the product. You can then configure the WAN for a static
IP address, DHCP Client or PPPoE client using appropriate configuration guidelines that follow
in order to obtain the license key. Once the key has been obtained, the web management
interface (WMI) can be used to continue configuration.
Configuration
Note: The WAN port of the AG must be connected to a live network that can access the Internet in
order to retrieve the license key from the license key server.
Log in by typing admin then password: admin. Type y[es] when prompted to configure settings.
The initial minimal WAN port configuration mode will be displayed as shown in Figure 1.
Ready. Press enter to login.
NSE
Login: admin
Password: *****
NO LICENSE KEY HAS BEEN ENTERED.
IN ORDER TO PROCEED WITH INSTALLATION.
SEE USER'S GUIDE FOR LICENSE KEY INFORMATION.
INSTALLATION WILL NOW TRY TO CONTACT THE NOMADIX LICENSE KEY SERVER.
IN ORDER TO PROCEED, THE NSE MUST BE ABLE TO CONNECT TO THE INTERNET.
DO YOU WANT TO CONFIGURE THE NSE'S IP AND DNS SETTINGS? [yes/no]: y
Configuring minimal WAN interface connectivity parameters:
Configuration Mode
Figure 1: Initial minimal WAN port configuration.
Select the desired configuration mode and use the following steps to configure the WAN port for
either Static IP, DHCP client or PPPoE.
computer's Ethernet port.
gateway via the administrative IP address after the AG finishes powering up.
The administrative IP address is 172.30.30.172 shown in Table 2.
Netmask
255.255.0.0
A LICENSE KEY MUST BE ENTERED
[static
2
Gateway DNS (if needed)
172.30.30.172 4.2.2.1
] (static, dhcp, pppoe) :
02.11.2016