Chapter 3 - Computer Module Installation - Elo Touch Solutions IDS 3201L User Manual

Chapter 3
Computer Module Installation
Installation
1. Use a Phillips head screwdriver to remove the access cover plate on the back of the
touchmonitor.
2. Slide the Computer Module all the way into the bay until it snaps into place.
3. Tighten the thumbscrews to secure the computer module inside the bay.
NOTE: If any cables are connected to the computer module, a cable security cover is
included with the computer module kit. Install it by attaching the mounting clip and bracket as
shown in the user guide for the computer module and then fastening the thumbscrews on the
cover.
User Guide–Computer Module
UM600040 Rev A, Page 6 of 33