Table of Contents
Advertisement
SURFACE COOKING
BURNER
GRATES
OPERATING
RANGE
DURING
A
Burner grates are interchangeable.
POWER
FAILURE
When reinstalling,
place indented
1. Hold a lighted match to the desired
sides together so straight sides are at
surface burner head.
front and rear.
2. Turn knob to START. The burner
CAUTION: Burner grates must be
will then light.
properly positioned before cooking,
3. Adjust the flame to the desired level.
SURFACE
BURNERS
CAUTION: When lighting surface
burners, be sure all controls are in the
A shipping screw is used to secure
OFF position. STRIKE MATCH FIRST
each burner during transportation,
and hold in position before turning knob
Once the range is installed, these
on. THE OVEN WILL NOT OPERATE
must be removed to allow quick and
DURING POWER FAILURES.
easy removal of the burner.
SELECTING
FLAME
SIZE
LIGHTING
SURFACE
BURNERS
If a knob is turned very quickly from
HIGH to WARM setting, the flame may
Your range is equipped with pilotless
go out, particularly
if burner is cold. If
ignition which eliminates the constant
this occurs, turn the knob to the OFF
standing pilot,
position. Wait several seconds, then
TO LIGHT BURNER:
light again.
1. Place utensil on burner grate.
HIGH
High flame needed to bring foods
2. Push in and turn knob to the START
quick}y to rolling boil.
position. A clicking sound will be
heard and the burner will light.
MEDIUM
After the burner lights, turn knob to
Lower flame required to keep foods at
the desired flame size.
a medium boil.
WARM
Very low flame to keep foods warm.
START
This position for ignition only.
Flame should be adjusted so it does
net extend beyond the edge of
cooking utensil. This is for personal
safety and to prevent damage to
cabinets above range.
9
Advertisement
Table of Contents
