Measurement Mode (Normal Operation) - MSA ALTAIR 5 Operating Manual

OPERATION
If this option is enabled through the MSA Link
displays a blinking "
perform a Fresh Air Setup:
(1) Press the [
The Fresh Air Setup is skipped and the instrument goes to the
•
Measuring page (Main page).
(2) Press the [
The instrument starts the FAS sequence and the FAS screen
•
displays.
A progress bar shows the user how much of the FAS has already
•
been completed.
At the end of the FAS Calibration, the instrument displays either
•
"
FRESH AIR SETUP PASS
"
FRESH AIR SETUP FAIL
3.3.

Measurement Mode (Normal Operation)

In Normal Operation mode the user can check the Minimum and Peak
readings prior to clearing the STEL and TWA values or performing a
Span and Zero Calibration.
The following options pages can be executed from the Normal Operation
screen (for further information see Section 7.5):
Peak Page
Min Page
STEL Page
TWA Page
Date Page
Last Cal Date
Cal Due
Motion Alert
28
FRESH AIR SETUP?
] button to bypass the Fresh Air Setup.
] button to perform the Fresh Air Setup.
This page shows the peak readings for all
sensors.
This page shows the minimum readings for the
oxygen sensor.
This page shows the calculated STEL readings of
the instrument.
This page shows the calculated TWA readings of
the instrument.
This page shows actual date settings of the
instrument.
This page shows the date of the last calibration.
This page shows the set date for the next
calibration
This page allows the Motion Alert Feature to be
activated or deactivated.
ALTAIR 5 - Operating Manual
TM
software, the instrument
", prompting the user to
" or
".
MSA
US