Installation Instructions - Lippert Components Jack-It Manual

Resources Required
9/16" Socket Wrench
3/4" Socket Wrench

Installation Instructions

1� Remove the tongue jack from the coupler. Position the
PowerTower™ (Fig�1G) on the coupler. Place the
tongue jack on the PowerTower (Fig�1G) and secure
both to the coupler using 3 nuts, bolts and washers each
(Fig�1H, 1I and 1J).
Note: If there is no tongue jack, attach the PowerTower
(Fig�1G) to the coupler on the front of the trailer using 3
nuts, bolts and washers each (Fig�1H, 1I and 1J).
2� Attach the stinger (Fig�1F) to the PowerTower
(Fig�1G) using the NoMotion™ pin and washers
(Fig� 1C, 1D and 1A). For safety, insert the cotter pin
(Fig�1B) through the hole at the end of the NoMotion pin
(Fig�1C) after tightening securely.
3� Attach the base (Fig�1E) to stinger (Fig�1F) using the
NoMotion pin and washers (Fig�1C, 1D and 1A). For
safety, insert the cotter pin (Fig�1B) through the hole at the
end of the NoMotion pin (Fig�1C) after tightening securely.
www.lippertcomponents.com (574) 537-8900
Jack-It™
Aftermarket Manual
A
D
H
I
J
Fig�1
2
Rev: 02.17 - Jack-It™ Aftermarket Manual
E
B
C
F
G