Table of Contents
Advertisement
Step3 Fix the Ethernet cable to the pole by cable ties.
Bend the Ethernet cable and fix it appropriate so that does not take the load on the Ethernet
cable.
Does not take the load to the cable
Step4 Wrap the self-bonding tape around the Small lid for waterproofing.
Using an appropriate length of self-bonding tape, wrap the tape around both the small Lid of
the WT (at its base) and spacer one complete turn (1). After one turn, wrap about some turns
around the Ethernet cable by overlapping one-half of the previous turn (2). Reverse the
wrapping direction and wrap about another some turns back to the small Lid (3).
Cable ties
Figure 5-49
(1)
(3)
Figure 5-50
The length more than 75mm
5-67
(2)
Advertisement
Table of Contents
