Table of Contents
Advertisement
2. WT installation procedure
Attach the antenna adaptor to the WT with the O-ring using four M3 screws. (Figure 6-22 & Figure 6-23)
These (adaptor, the O-ring, M3 screws with Washers x 4 paces) are attached articles of the antennas of
RADIO WAVES, INC. Tightening torque：0.6 N･cm
WT
Adaptor
・ When you attach the antenna adaptor to the WT, it should take the matched shape of each
other.
・ If it takes the unmatched shape of each other, the radio can not work normally.
WT (External Antenna Type)
Adaptor
O-ring
4 x M3 screws with Washers
Tightening torque：0.6 N･m
WT (External Antenna Type)
Figure 5-24
Figure 5-25
5-44
OK
NG
Advertisement
Table of Contents
