Table of Contents
Advertisement
Cable contents
Interface
Cable length
Connector shape
Pin assign
Cable type
Range of applicable
outer
Cable contents
Applicable Cable
Applicable terminal
Note
contents
PoE specification
The PoE PSE which
confirmed connection
with the WT.
Remark *1: JRC doesn't offer PoE PSE. Please buy PoE PSE directly from PoE PSE bender.
Please connect a ground wire to FG terminal surely.
At the time of trouble and short circuit, It may cause the electric shock.
(1) Ethernet Cable
connect the WT and the PoE PSE
1000BASE-T, 100BASE-TX, 10BASE-T
Maximum 100m.
In case of PoE HUB use：100m is from the WT to PoE HUB
In case of PoE injector use: 100m is from the WT via PoE injector to
HUB. (Because, there is no function of terminate PHY in the PoE
injector)
RJ-45
- ETHER signal: MDI-X
- POWER: IEEE802.3at Type2
Ethernet cable for outdoor,
diameter φ4.0 mm - 7.0mm
(2) Ground wire
Connect the ground wire.
Ground wire 1.6□ (AWG#14)
FG terminal M6 nut.
ground resistance is 100 Ω or less
(3) power supply by PoE PSE
Power supply for The WT is supplied by PoE PSE (Power over
Ethernet Power Sourcing Equipment).
- POWER: IEEE802.3at Type2
- Interface: 1000BASE-T
- PoE injector : PD-9001G-40/SP（Microsemi）*1
(The
PD-9001G-40/SP
functionality.)
STP(Shield Twisted
provides
5-65
Pair)
also
surge
protection
Advertisement
Table of Contents
