Table of Contents
Advertisement
Step2 Select the Configuration＞Network Configuration tab.
-
IPv4：Set IP address, subnet mask and default gateway
-
IPv6：Set Disable or Enable. If enabled, set IP address, default gateway
-
Click the Setup button. "Setup" makes configuration changes. These changes are
reflected after Reset.
-
ETHERNET Configuration：Set the interface class 1000BASE-T(AUTO)、
1000BASE-T(Fixed), 1000BASE-T(AUTO), 100BASE-TX/FULL(FIXED)、
100BASE-TX(AUTO) or 100BASE-TX/HAFE(Fixed)
-
Management VLAN TAG: Set Enable or Disable. If enabled, set VID, COS
-
OpS1-3: Set Enable or Disable. If enabled , set IP address (IPv4 or IPv6)
-
Community name (SNMP v2)1-3: Set the GET / SET community name for each OpS1-3.
-
User name (SNMP v3) 1-3: Set user name, authentication protocol, authentication
password, encryption protocol, encryption password and access control for each OpS1-3.
-
Trap destination 1-2: Set Enable or Disable. If enabled, set IP address (IPv4 or IPv6) and
SNMP Version (v2 or v3).
-
Click the Setup button.
The basic configuration of the WT (Master) is completed by the above and works.
Figure 5-4 Radio configuration tab (master)
5-30
Advertisement
Table of Contents
