Table of Contents
Advertisement
The Receiving level aims for a direction adjustment mode level of the graph (ATPC OFF)
about "5.7.2 The receive level and the distance"..
In addition, it becomes a normal operation mode when you finish a direction adjustment
mode. The receiving level is optimized by ATPC function.
Therefore, the MT display level of the receiving level becomes the normal operative value
of the graph (ATPC ON) about "5.7.2 The receive level and the distance".
You can confirm the change of the Receiving Level in high (Receiving Level is high) / low
(Receiving Level is low) of the sound when you turn on "sound on" button. The
correspondence OS is Windows XP. This function does not work in Winodws7.Sound
function works on WINDOWS XP.
Step5 After Antenna Alignment, measure the Received Blocks Discarded Rate.
Select the downlink modulation scheme and the uplink modulation scheme (Only Master)
QPSK, 16QAM, 64QAM
Usually set the downlink and the uplink for the same modulation scheme.
Step6
Check the Received Blocks Discarded Rate
Push the Clear button to reset a counter and start the measurement. Update the
measurements automatically.
Step7 END the Antenna Alignment,
Click the "End and Reset" button to finish the Antenna Alignment mode
The "Reset ok" dialog appears. Clicking the OK button executes the reset. After 20
seconds, reset is completed.
5-50
Advertisement
Table of Contents
