Table of Contents
Advertisement
After inserting the guide pin of the WT into the guide hole, presses the WT to the plate.
While you are pressing the WT, you must be tightening the four M5 screws which included in WT.
Tightening torque：2.7 N･cm
Plate
2) Horizontal polarization
When using H (Horizontal) polarization, the guide pin of the WT should be rotated to the right and
inserted into the H guide hole of the plate.
Figure 5-29
4 x M5 screws / tool: Allen wrench (Width across flats 4)
Tightening torque 2.7 N･m
Figure 5-28 Installed WT to an antenna for vertical polarization
Guide pin
Plate
Figure 5-30 Horizontal polarization
5-46
H guide hole
Advertisement
Table of Contents
