Auto Start; Auto Detect Profile - Arcom QAM Snare Snoop User Manual

Auto start

The Auto Start/Stop setting allows the unit to turn on and
establish GPS lock automatically when power is applied, as
when the vehicle is started. It will NOT automatically enter
detector mode, as it is not intended to detect leaks while
cradled. This setting also controls an Auto Off counter
feature, which powers the device down when power is
disconnected, as the vehicle is turned off.

Auto Detect Profile

The Auto Detect Profile turns on and off the ability to
automatically switch between detection profile (Analog, QAM,
Pilot/QAM, and OFDM) based on GPS coordinates. Different
sections of the cable network can have different channel
lineups and can utilize different modulation format, or can
be in R-PHY node areas. Since the detection schema can be
different in different areas, the Auto Detection Profile feature provides a means to for
the detector to automatically switch to the correct detection profile without user
involvement. The QAM Snare Server communicates with the detector and based upon
its GPS location tells it which mode it should be in. Additionally, when Auto Detection
Profile is ON, and Wi-Fi & QS Server credentials have been entered, the Snoop will
connect to a selected server to send GPS Time and coordinates to the server. This is
used to log Snoop usage activity only, and no leakage data is recorded. "GPS SYNC" is
required when Auto Detect Profile is turned "ON".
When Auto Detection Profile is ON, the main menu will indicate this by adding
"AUTO" to the detector menu option.
8