Possibilities For Insertion - Electrolux EHF3920BOK User Manual

10 www.electrolux.com
• There is a risk of fire when the appli-
ance is in connection with an extension
cable, an adapter or a multiple connec-
tion. Make sure that the ground con-
nection agrees with the standards and
regulations.
• Do not let the power cable to heat up
to a temperature higher than 90° C.
Make sure that you connect the blue neu-
tral cable to the terminal with a letter "N"
on it. Connect the brown (or black) phase
cable to the terminal which has a letter
"L". Keep the phase cable connected at
all times.
8.3 Replacement of the
connection cable
To replace the connection cable use only
H05V2V2-F T90 or equivalent type. Make
sure that the cable section is applicable to
the voltage and the working temperature.
The yellow/green earth wire must be ap-
proximately 2 cm longer than the brown
(or black) phase wire.
8.4 Building in
min. 650 mm
If several 30 cm hobs are to be installed
side by side into the same cut out, an as-
sembly kit including a support side brack-
et and supplementary seals is available at
our Service Centres. The relevant installa-
tion instructions are supplied within the kit
package.
R 5mm
55mm
+1
490 mm
+1
270 mm

8.5 Possibilities for insertion

Kitchen unit with door
The panel installed below the hob must
be easy to remove and let an easy access
490 mm
in case a technical assistance intervention
is necessary.
270 mm
A) Removable panel
B)
Space for connections
CAUTION!
Install the appliance only on a
worktop with flat surface.
30 mm
min 20 mm
A
(max 150 mm)
60 mm
B