Table of Contents
Advertisement
Figure 1
1 2 3 4 5
There must be no cut or stray strands of
wire present. The cord clamp must be
correctly attached to the outer sheath.
Connection
Appliance con-
trol circuit
The yellow / green earth wire (B)
must be approximately 2 cm lon-
ger than the live and neutral wire
(A).
6.
Secure the cable by means of the
clamp screws and refit the terminal
block cover.
According to the current regula-
tions only a qualified electrician or
competent person can replace the
mains cable.
Min. size
Fuse
cable /
flex
6 mm²
30 A
A
B
8.4 Building In
min. 600 mm
min. 55 mm
30 mm
A)
supplied seal
B)
supplied brackets
Seal the appliance to the worktop with the
supplied sealant placed on the edges of
the cut out.
Fix the hob with the relevant fixing clamps
and screws, as shown in the graphic.
When the screws have been tightened,
the excess seal can be removed.
CAUTION!
Install the appliance only on a
worktop with flat surface.
8.5 Possibilities for insertion
Kitchen unit with door
The panel installed below the hob must
be easy to remove and let an easy access
in case a technical assistance intervention
is necessary.
ENGLISH
11
min. 650 mm
550 mm
A
B
Advertisement
Table of Contents
