Operating; Starting And Stopping Operation; Main Menu - Stairville BossFX-1 User Manual

Operating

7 Operating

7.1 Starting and stopping operation

Starting
Stopping

7.2 Main menu

Main menu
'Aut'
18
Complete the following steps to start operation:
1. Verify that all required laser safety precautions have been taken. Make sure
that there is no one in the reach of the laser beam.
2.
Insert the safety key into the lock.
3.
If not already done, connect the device to the mains.
4.
After a few seconds, the fan and the motors start to work. The display shows
the current operation mode. The device is now operational.
5.
Turn the foot switch on.
6.
Turn the safety key to the 'ON' position to turn the laser beam on.
Complete the following steps to stop operation:
1.
Turn the safety key to the 'OFF' position to turn the laser beam off and remove
the key. Keep the safety key under control.
2.
Turn the foot switch off.
3.
Disconnect the device from the mains.
Press [MENU] to activate the main menu and to return to the main menu from a sub-
menu. Use [ENTER] to select further options. Use [UP] and [DOWN]to change the
respectively indicated value. When the display shows the desired value press [Mode].
The set values are retained even when the device is disconnected from the mains
power supply.
The following table shows the setting options.
Menu level 2
Operating mode 'Preprogrammed automatic show'
'AutP'
'AutL'
LED lighting set
Menu level 3
Selecting an automatic show for the LED spots and derby
effects ( 'AP01' ... 'AP18' )
'S.01' ... 'S.99'
Selecting an automatic show for the Laser ( 'AL01' ... 'AL06' )
Meaning
Speed of the selected auto-
matic show