wsm V3307-DI-T-E2B Workshop Manual page 108

V3307-DI-T-E2B, WSM
Governor Fork Lever Assembly
1. Pull off the governor fork lever shaft (2) with the extra bolt (Dia. :
4.0 mm (0.16 in.), Pitch : 0.7 mm (0.03 in.), Length : more than
25 mm (0.98 in.)) (1).
2. Unhook the governor spring (3) at the governor fork lever (4)
side.
3. Remove the governor fork lever assembly from the governor
housing (5).
(When reassembling)
• After reassembling the governor housing assembly, check the
movement of the governor fork lever assembly, the speed control
lever and the stop lever.
NOTE
• When assembling the inside parts, put the oil on each inside
part slightly.
• Be careful not to deform the start spring.
(1) Extra Bolt
(Dia. : 4.0 mm (0.16 in.),
Pitch : 0.7 mm (0.03 in.),
Length : more than 25 mm (0.98 in.))
S-39
ENGINE
(2) Governor Fork Lever Shaft
(3) Governor Spring
(4) Governor Fork Lever
(5) Governor Housing
W1139749
KiSC issued 01, 2009 A