wsm V3307-DI-T-E2B Workshop Manual page 133

V3307-DI-T-E2B, WSM
Replacing Valve Bridge Shaft
1. Remove the used valve bridge shaft (2).
2. Clean the valve bridge shaft mounting hole.
3. Using valve bridge shaft replacing tool (3), press in the new shaft.
(Refer to "5. SPECIAL TOOLS" at "GENERAL" section.)
(1) Valve Bridge Arm
(2) Valve Bridge Shaft
(3) Valve Bridge Shaft Replacing Tool
Push Rod Alignment
1. Place the push rod on V blocks.
2. Measure the push rod alignment.
3. If the measurement exceeds the allowable limit, replace the push
rod.
Push rod alignment Allowable limit
(1) Push Rod
Oil Clearance between Tappet and Tappet Bore
1. Measure the tappet O.D. with an outside micrometer.
2. Measure the I.D. of the tappet bore at the most wear part with a
small hole gauge.
3. If the oil clearance exceeds the allowable limit or the tappet is
damaged, replace the tappet.
Factory spec.
OIl clearance between
tappet and tappet bore
Allowable limit
Tappet O.D. Factory spec.
Tappet bore I.D. Factory spec.
(1) Tappet
S-64
ENGINE
A : 31.1 to 31.7 mm (1.23 to 1.24 in.)
W1042985
0.25 mm
0.0098 in.
W10292900
0.020 to 0.050 mm
0.00079 to 0.0019 in.
0.07 mm
0.003 in.
9.965 to 9.980 mm
0.3924 to 0.3929 in.
10.000 to 10.015 mm
0.39370 to 0.39429 in.
(2) Tappet Bore
W1043774
KiSC issued 01, 2009 A