wsm V3307-DI-T-E2B Workshop Manual page 117

V3307-DI-T-E2B, WSM
Flywheel
1. Install the stopper (1) to the flywheel (2) so that the flywheel (2)
does not turn.
NOTE
• Do not use an impact wrench. Serious damage will occur.
• There is one positioning pin in the crankshaft gear and it is
installed in the flywheel (2).
2. Detach the flywheel screws (3) and set the flywheel guide screws
(4).
3. Remove the flywheel (2) using jack-up screws (5).
(When reassembling)
• Apply engine oil to the flywheel screws (3).
• Before fitting the flywheel (2) and the crankshaft gear together,
wipe oil, dust and other foreign substances off their mating faces.
• The flywheel (2) and the crankshaft gear are fitting together in
just one position. Make sure they are tightly fit and drive the
screws.
Tightening torque Flywheel screw
(1) Stopper
(2) Flywheel
(3) Flywheel Screw
S-48
ENGINE
98.1 to 107 N·m
10.0 to 11.0 kgf·m
72.4 to 79.5 lbf·ft
(4) Flywheel Guide Screw
(5) Jack-up Screw
W1060354
KiSC issued 01, 2009 A