Ricoh DDST A, DDST B Operating Instructions Manual page 41

Messages/Second messages
NV-RAM Error
Output Tray changed.
Paper size/type mismatch.
Change settings to:
xxx yyy
[Print] without below
mode?
Printer Font Error
Print overrun.
Paper Tray is in use.
Reset Paper Tray correctly.
DToner is almost empty
Add toner
Tray # Error
Unauthorized user access.
USB has a problem
Causes
An error has occurred in the
printer.
The output tray has been changed
because of the paper size limita-
tion of the selected tray.
There is no paper tray that
matches the paper settings se-
lected under Auto Tray Select.
xxx indicates the tray number.
yyy indicates the paper size
and the paper type.
This is an alert message con-
cerning a paper tray in auto
tray select.
An error has occurred in the
font file.
The image data has been
thinned out due to image com-
pression.
The specified paper tray is in
use by another function, such
as the copier function.
The selected paper tray does
not exist or is not set correctly.
Toner is running out.
An error has occurred with the
paper tray.
# indicates the tray number.
Print job canceled due to user
restrictions.
An error has occurred in the
USB interface.
The Printer Function
Solutions
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Select the correct output tray.
Press [JobReset] to change the
paper tray settings, or press
[FormFeed] to print regardless.
For details about the paper
tray settings, see General Set-
tings Guide.
Press [Print] to cancel the mode
and print the job.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Increase memory capacity.
When installing a memory
module in the machine, con-
tact your sales or service rep-
resentative.
Wait until the other function
has finished using the speci-
fied paper tray.
Set the paper tray correctly.
Replace the toner cartridge
soon to prevent poor print
quality.
Press [JobReset] to change the
paper tray settings, or press
[FormFeed] to select another
paper tray and print.
Check the User Code permis-
sion status.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
5
35