Section 2: Specifications - Vanair AIR N ARC I 300 SERIES Operation Manual

®
AIR N ARC I-300 SERIES ALL-IN-ONE POWER SYSTEM
SPECIFICATIONS
TABLE 2A: ENGINE, HYDRAULIC SYSTEM, WELDER, AND GENERATOR SPECIFICATIONS
SYSTEM INFORMATION
Engine:
Engine Oil Capacity:
Engine Idle RPM (No Load):
Engine RPM (No Load):
Hydraulic Fan RPM:
Fuel Consumption:
Fuel Type:
Operating Temperature Limits:
Hydraulic Pressure Comp Setting @ Tool Port, Work
Valve Closed:
Standby Pressure @ Tool Port, Work Valve Open -
Required Only for Closed Center Machines:
Hyd Flow @ Idle @ 2000 PSI (100-120° F Hyd Temp for All):
Hyd Flow @ Full Speed @ 2000 PSI:
Hyd Flow @ Full Speed @ 0 PSI Hyd:
Hyd Flow w/ Cmpr Low and High Speed, 0 PSI Hyd:
Hyd Flow w/ Cmpr Low and High Speed, 2000 PSI Hyd:
Rated Welder Output:
Welding Leads:
Welder CC Max Volts:
Welder CC Max Amps:
Welder CC VDC @ Max Amp:
Welder CV Min Volts:
Welder CV Max Volts:
DC 12 Volt Charge Volts (Idle):
DC 12 Volt Boost Volts:
I
For specification and requirements regarding the Kubota
II
Diesel Fuel Specification Type and Sulfur Content% (ppm) used must be compliant with all applicable emission regulations for
the area in which the engine is operated.
Engine manufacturer recommends a fuel sulfur content of less than 0.10% (1000 ppm). For fuels with a high sulfur content
0.50% (5000 ppm) to 1.0% (10000 ppm) a more frequent engine oil and oil filter change schedule is needed (approximately
half). DO NOT USE fuels with a sulfur content greater than 1.0% (10000 ppm). For additional information on fuel for this
engine, consult Section 4.10 (Extreme Condition Operation), and the Engine Operator's Manual.
Not recommended for bio-diesel blends over 5%.
®
SECTION 2:
Diesel 25HP
5.5 Quarts 15W40 (Refer to Engine Operator's Manual for
Extreme Conditions)
2880
3660
2350
1.25 GPH at Full Engine Speed/Load 9.6 Hour Runtime
Diesel Fuel
0° F to 110° F (-18° C to 43° C); Cold Weather Kit extends
temperature range from 0°F to -40° F (-18° C to -40°C)
3000
350
4.1
6.5
9.9
5.5
2.1
300A High Frequency DC/CC, DC/CV; 100% Duty Cycle @
270 Amps
25 or 50 Ft Optional
60 min
285 min
15
15
40
14
16
®
25 HP Diesel Engine, refer to the Engine Operator's Manual.
090045-OP_r1

SECTION 2: SPECIFICATIONS

SPECIFICATION
I
II
Continued on next page
PAGE - 15